Chl Chlf Series Stainless Steel Light Duty Pump Horizontal Multistage Small Centrifugal Pump

 Introduction  

CHL/CHLF is a kind of multi-functional products.It can be used to convey various medium from tap water to industrial liquid at different temperature and with different flow rate and pressure. CHL type is applicable to conveying non-corrosive liquid, while CHLF is suitable for slightly corrosive liquid.
Application:
CHL,CHLK and CHLF(T) type pump are mainly used in industrial field:

* Air conditioner system

* Aquaculture

* Cooling system

* Environmental application

* Water treatment processing (water purification)

* Fertilization / Measuring system

*Other special applications

Application medium: 
*Thin and clean non-flammable and non-explosive liquid without solid granules and fibers.
*Mineral water, soft water, pure water, edible vegetable oil and other light chemical mediums.
*When the density or viscosity of to-be-conveyed liquid is larger than that of water, it is necessary to select a driving motor of high-power.
*Whether a specific liquid is suitable for the pump depends on many factors, among which the most important ones are chlorine content, PH value, temperature, solvent and oil content.

Curve conditions:
Following conditions are suitable for the performance curves shown above:
*All curves are based on the measured values of 50Hz: constant motor speed 3500r/min;
*Curves tolerance in conformity with CE;
*Measurement is done with 20 ºC are-free water, kinematic viscosity of 1mm ² /sec;
*The operation of pump shall refer to the performance region described by the thickened curve to prevent overheating due to too small flow rate or overload of motor due to too large flow rate.
Motor:
*TEFC motor 2-pole
*Protection class: IP55
*Insulation class: F
*Standard voltage, 50Hz: 1×220-240V
3×220-240V/380-415V
*Standard voltage, 60Hz: 1×220-240V
3-220-240V/380-415V
*Single phase motor(max): 2.4kw
Operation condition:
Liquid temperature:
Normal temperature type: -15 ºC~+70 ºC
Hot water type: -15 ºC~+110 ºC
Ambient temperature: up to +40 ºC
Max.operation pressure: 10 bar
Max.inlet pressure is limited by max.operation pressure.

 Pump parameter:

Installation drawing: 

Performance Curve: 

Our Contacts:

Performance Curve: